[Bentbolt]

Adams custom rifles has some while back. PVA would be my next stop

[Bentbolt]

I bet chadd would like that. He is a nice guy but if he isn't in favor of the build he wants it to favor him. Do you have a shop to make your reamer already?

[Bentbolt]

Elkhamr here been a member for awhile but have limited posts as I usually find an answer to my questions in the archived pages. I'm planning a build and need to have the barrel taken off my action by someone that has the tools and knowledge to do so without tweeking my action. any help will be greatly appreciated…thank you in advance !

a Remington action wrench will do the job. a local guy that does remington only wanted to check my tikka out and the barrel was shot out so I let him take the barrel off. he had to cut a relief in front of the action to get the barrel off. I just bought a new gun last week and im just shipping the barreled action to my smith and he can remove it and install a new barrel on.

[Bentbolt]

I have a tikka t3 action and trigger for sale or trade. pm if interested

[Bentbolt]

Hot loads no. A few was warm to try to see if I could get speed up but dropped it back down. It's going to smith to have barrel to come off. I'm looking to trade action for stainless for my build if I can't then I'm using the old action for biuld. Smith said he is sure barrel is done for.

[Bentbolt]

thanks, I figured so, im new to shooting so pardon myself. I have had other rifle but never shot a lot.

[Bentbolt]

Pm returned

[Bentbolt]

check your crown for dents or anything else that would make it not 100%
have you let some one else shoot your gun?

[Bentbolt]

No it's just. A 2 die set

[Bentbolt]

I seen short action customs had a few actions I'm not sure rh or lh

[Bentbolt]

Cheap jump on it. It because people are hoarding it. I needed some while back to take my girls out to shoot and paid 65 a brick. I have seen it all the way to 125 and I laughed and walked away. I'm getting Lapua 50 for $7. And happy with it

[Bentbolt]

I bought a the same u bought mine miced .2445. It fit in the action tight. I have a chassis and made it .0003 small for press fit.

[Bentbolt]

I think I have a short laying around somewhere

Let me know I need one sooner the better. If not looks like I will buy a set of two

[Bentbolt]

i prefer a short so I can machine it to my desired length but I will take a long if need be. I live 11 miles from brownells and can buy a set there but I figured some one might have an extra one lying around

[Bentbolt]

All parts are in snail mail. I have abunch of readers and indexing tool on deck then I'm gonna knock out a stock I will post it once I get it knocked out