-
would like some information on the tikka t3x ctr 24" barrel 6.5cm
hello guys brand new here i am very seriously looking into the tikka t3x ctr some of my biggest concerns are barrel replacement were can i find a new barrel for it if the need comes and also are the barrels cold hammer forged also with the ctr i'm realy concerned on the cheek height will i get a good cheek weld but yet also have good eye to scope alignment so i am comfortable and not having to raise my head just to see threw the scope my plans are to use a 30mm scope with a 50-56mm objective thank you for your time
-
3 Replies
-
You can use any barrel you wish, it will just need to be profiled, chambered and finished by a competent gunsmith, pretty much like most bolt action rifles.
I have a RZR Gen II on my CTR and cheek weld is fine, your face might be different from mine so you should always expect to make some adjustments to the cheek piece, scope mounts and rings. I added a 1/16″ cheek eeze to give it more grip and a little more height. Cheek weld can be adjusted pretty easily with some tape and fabric.
-
http://patriotvalleyarms.com/replacement-tikka-t3-ruger-american-pre-fit/
Here's a link to a pre fit barrel.
-
Tikka factory barrels are made by Sako which are well made. If you want to change out for any other – you can use nearly any custom supplier
Log in to reply.