-
Vortex hst 6-24×50 on a t3varmint stainless ring hight
Hi guys
Just wondering if anyone has mounted a vortex viper hst 6-24×50 to a t3 varmint ss with vortex matched rings and a tikka picatinny rail not sure if the low rings will be to low or have to go medium
Cheers -
4 Replies
-
Here's my T3 Varmint with a Viper HSLR 6-24 x 50mm
The rings are Med PRW's @ .97″ …same height as the Vortex MED match set you mentioned.
The rail is a 0 MOA Mountain Tactical…”Cut to receiver length”…lots of room for scope movement front to back…I could easily get away with a low ring @ .87″ with this setup. You should be able to run a low ring even with out cutting the rail but you will be limited to scope position.Depending on where you place the scope for your shooting position the objective bell on the Vortex 6-24 x 50mm scope with a full rail and “low” rings may contact each other.
I use MED rings for all my rifles because its more comfortable for prone shooting in the field.
-
Thanks a lot dog down just what I was chasing think I might go the mediums then possibly have enough room for a 20moa rail later
-
The MED will work fine…I switch this scope to another tikka rifle with 20moa EGW rail setup.
-
Med with mountain tactical works well, no prob
Log in to reply.