Forums › Forums › Show off your Tikkas! › T3 .308 w/Vortex PST
-
T3 .308 w/Vortex PST
Posted by CEL317 on November 9, 2012 at 9:03 pmNew to the forum so I thought I'd introduce myself by posting my setup.
Tikka T3 Lite Stainless in .308
EGW HD Picatinny Rail Scope Mount 20 MOA
Vortex Viper PST 6-24×50 FFP w/EBR-1 MOA Reticle
Vortex 30mm Precision Matched Mounts
Vortex Flip Caps
Vortex Optics Bubble Level
Vortex Magnification Lever
Harris Engineering S-BRM Hinged Base 6 – 9-Inch BiPod
T-Nuts BPL-Micro (“PodLock”)
Limbsaver SAKO 75/FINLIGHT SYN BUTT PAD
HSS Bolt Handle / Shroud Combo
Accu-Shot Monopod BT04-QK – Standard height Stud Mount with QK01 Quick Knob
Extended Magazine 5 RoundsGFRoSTY replied 10 years, 9 months ago 8 Members · 12 Replies -
12 Replies
-
1 Bullseye
Thanks guys! I only have 160 rounds down range with it, but I really like it so far. It's been a few years since I shot on a regular basis so I'm a bit rusty and I think it shoots better than I do at the moment, but I'll get there. The left shot on group 2 was obviously my fault.
[img][/img] -
66 Bullseyes
Looks like a keeper. I'm trying to improve my rifle shooting as well. I'm still pretty inconsistent. I could blame the rifle, or ammo, or wind, but I think spread out groups are due to me. Time will tell. Thanks for sharing! – Todd
-
1 Bullseye
Don't discount ammo. I am very inconsistent with non-match ammo. I bought several boxes of Winchester PowerPoint because it cost a lot less and wanted to be able to shoot more. Well, I was all over the place and got pretty frustrated thinking it was me. I tried the FGMM's and it made a huge difference. Just something to think about.
-
1 Bullseye
Would slightly lower scope mounts work with that scope?
-
1 Bullseye
I think the medium mounts should work fine. I went with the high mounts because I am planning on putting it in an XLR Chassis and didn't want to have to replace the mounts.
-
1 Bullseye
I think the medium mounts should work fine. I went with the high mounts because I am planning on putting it in an XLR Chassis and didn't want to have to replace the mounts.
Oh ok, that makes sense
-
1 Bullseye
That's very nice shooting for both you and your rifle. Can't wait to see it in the chassis. 😉
-
1 Bullseye
what is the cheek pad/ammo holder on the stock?
-
1 Bullseye
Very nice rig there!!
my Tikka t3 super varmint in .308 is just being run in at the moment and waiting on the same scope as you !
Log in to reply.