Replies – Forums – Palmetto.T3 – Tikka Shooters

Forum Replies Created

Palmetto.T3

Member
October 11, 2015 at 6:01 am in reply to: What’s required to mount a scope on a T3 Varmint

1 Bullseye

Dog Down

Appreciate the insight. I see you like your Leupold PRW rings. Have you tried the QRW?

Look like same rings just ability to remove without tools
Palmetto.T3

Member
October 8, 2015 at 2:18 am in reply to: Quick Disconnect Cantilever Scope Mount on Tikka Performance rail?

1 Bullseye

Okay I tried this out once I looked my rail. Worked great, nice and tight, good fit.

BUT….it put the scope WAY too high. You need a step ladder to get a cheek weld with that setup.
Palmetto.T3

Member
October 8, 2015 at 2:15 am in reply to: Newbie with a T3 Super Varmint .223

1 Bullseye

Welcome from Saturated South Carolina.

I'm a recent T3 owner as well.
Palmetto.T3

Member
October 8, 2015 at 1:56 am in reply to: What’s required to mount a scope on a T3 Varmint

1 Bullseye

Dog Down could you use low rings in that configuration? It looks like the picture of the receiver length rail you could go with lower rings.

I'm setting up for deer hunting so I want my scope as low as possible.

Thanks
Mike