Forum Replies Created

  • Rancho_Loco

    Member
    November 24, 2013 at 2:55 pm in reply to: Pit marks bolt face
    Tikka Shooters Forum favicon icon 1 Bullseye

    Hi

    I have a T 3 varmint during a session at the range I noticed a few loose Winchester primers and signs of  gas leakage around the primer. When I got home I noticed that the loose primers had created pit marks around the firing pin hole.

    Can I still use the bolts with a slightly rough bolt face or do I need to change it. The gun still performed well even after I shot these faulty primers

    umm, those aren't faulty primers.  You're running too hot.  Stop shooting those loads, and re-read your reloading manual in regards to pressure signs.

  • Rancho_Loco

    Member
    November 24, 2013 at 3:44 am in reply to: Tikka T3 .223 Magazine Modification
    Tikka Shooters Forum favicon icon 1 Bullseye

    There not .223 cases look like there from the other end of the scale over 30 calibre imo

    What?  You're kidding, right?

  • Rancho_Loco

    Member
    November 21, 2013 at 11:53 pm in reply to: Tikka T3 .223 Magazine Modification
    Tikka Shooters Forum favicon icon 1 Bullseye

    If you follow his thread to the end the conversion failed to perform.

    That's news to me!

    http://www.youtube.com/watch?v=7LgSQeApITw&list=FL_vg1Ki7Epxu9639qF7jV5Q