-
side note…I wouldn't take a chance of twisting a T3 action using an inside action wrench, in fact, I wonder if you already haven't! I do, however, use an inside action wrench to re-torque my barrels after I have taken them off, and need to put them back on. Using a torque wrench on the back end is very repeatable.
Not so much twisting but I agree there is a risk of bending the action if you were rough and were not paying attention to what you were doing, by the rear of the wrench not being kept central and pushing against the rear of the action.
I was aware of this and did pay attention 😉
